Searching for special capability – Sheet Metal Curling

Viewing 1 post (of 1 total)
  • Martin Hinckley
    Member
    Post count: 0
    #13854 |

    I am searching for a company that can perform a progressive curl on sheet metal 0.011″ to 0.013″ thick. The outside radius of the initial curl would be roughly 6 times the sheet metal thickness, and this radius would be approximately constant through an angle of 160 degrees. The radius would then increase from 6 times the material thickness to 10 times the material thickness over a roll angle of 135 degrees. The external radius of 10 times the thickness would then remain constant over an angle of 90 degrees. Thus the total curl would be about 385 degrees. The length of the curl (edge length) is about 2.5″ long.
    Anyone know of a company capable of preforming this type of curl?

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.